AdvancedEnergyOnline.com

 
We Empower YOU to Get Energizedtm 
U.S. Ordering:
Phone: 800-229-0453
email: info@advancedenergyonline.com
International Ordering:
Phone: (618) 893-1717
email: info@advancedenergyonline.com

Types of Photovoltaic Systems

Small Stand Alone DC System




Small Stand-Alone DC or AC System 
The small stand-alone system is an excellent replacement for propane or kerosene lights in a remote cabin, a recreational vehicle or a boat. The size of the photovoltaic (PV) array and battery will depend upon individual requirements. The actual sizing methods are discussed elsewhere. The PV array charges the battery during daylight hours and the battery supplies power to the loads as needed. The charge regulator terminates the charging when the battery reaches full charge. The load center may contain meters to monitor system operation and fuses to protect wiring in the event of malfunction or short circuit in the house. You can add more panels and an inverter to make this an AC Stand-Alone System.








PV Generation Combo

PV - Generator Combination
The PV - Generator Combination system may be an economical alternative to a large stand-alone PV system, because the PV array does not have to be sized large enough for worst case weather conditions. A gasoline, propane, diesel, wind, or micro-hydro generator combined with a battery charger can supply power when the PV array falls short. If the PV array is sized for average conditions, then during extended overcast situations or periods of increased load, the generator can be started. When batteries are low, the generator will power the AC loads in the house as well as a battery charger to help recharge the batteries. If the PV array is sized much smaller than needed for normal use, the generator can power peak loads such as doing laundry or pumping water and simultaneously run the battery charger to charge the battery bank. In addition to allowing for a smaller PV array, a back-up charging system may also allow use of a smaller battery bank. Generator and battery bank size must be chosen carefully for reliable system operation. See the system sizing section for more details on equipment choice. 

Utility Integrated System (Alternating
Current Solar System (not grid intertied)
)

For areas that don't have utility Intertie easily available or if you want backup power. Same as the Utility Intertie system below, but with battery storage. If your PV array is large enough you will only need the Utility (Grid) for backup power; i.e. extended cloudy periods.

 

Any of the systems above can be made into a hybrid system with the addition of a gas, wind, steam or micro-hydo generator.



Utility Intertie
(Alternating
Current Solar System (grid tied)
)

The utility intertie system is also used in a grid connected house. Instead of storing power in batteries, it is sold to the utility company. The Utility Intertie System employs a special type of inverter, which inverts DC power from the PV array into low distortion AC, acceptable for purchase by the local utility power company. Batteries are not required for storage. The power is delivered through a kilowatt-hour (kWh) meter to the utility grid as it is produced by the PV modules. A second kWh meter is used to measure the power consumed by the loads in the house. The user of this system will notice no difference from any utility system, except lower utility bills or possibly payments from the power company for excess electricity that is generated.  This type of system tends to be an optimum configuration from an
economic viewpoint because all the electricity is utilized by the owner during the day and any surplus is exported to the grid. Meanwhile, the cost of storage to meet night-time needs is avoided, because the owner simply draws on the grid in the usual way. Also, with access to the grid, the system does not need to be sized to meet peak loads.



AC Photovoltaic Module Intertie






AC Photovoltaic Module Intertie
At last ordinary home owners can begin to reduce their dependence on utility power for their electricity. This type of utility sellback system is comprised of PV modules with small inverters mounted on them. This allows the output of the inverter-module combinations to be connected directly to the AC line. The utility may require a second meter and disconnect. The installation cost of this type of intertie system is much lower than that of a large inverter system. A small system can be installed, and as finances allow, additional AC PV modules can easily be added to the system. 

 

 

 

 

Sun Power Water Power Wind Power System Components Design Resources Water Pumps
Lighting Batteries Fans - AC - Heating Large Appliances Small Appliances Miscellaneous

Home | Catalog | Ordering | Specials | Company Info | Resources | Search

 

U.S. Ordering:
Phone: 800-229-0453
email: info@advancedenergyonline.com
International Ordering:
Phone: (618) 893-1717
email: info@advancedenergyonline.com
Mailing Address:
Advanced Energy Solutions, Inc.
192 Gates Road.
Pomona IL 62975-2506
Tech Support:
U.S. Phone: (618) 893-1717
email: tech@advancedenergyonline.com

 

© 1999-2005 Advanced Energy Solutions, Inc